(Ex:350-001):

1.Which do NOT exist?
A. Per VLAN Spanning Tree (PVST).
B. Per VLAN Spanning Tree Plus (PVST+).
C. Per VLAN Spanning Tree Plus Plus (PVST++).
D. Rapid STP (RSTP).
E. Resilient STP (RSTP).
Answer: CE

3. OSPF is defined on a Frame Relay interface providing point-to-multipoint connections. The remote neighbors can reach this central site, but are complaining of routing failures between each of the remote sites. The central router has all the routes for each remote site. Based on this information, what can be diagnosed as the biggest potential problem?
A. An over-subscribed Frame Relay switch will cause some packet loss.
B. There are problems in the use of OSPF Authentication.
C. There is an incorrect selection of the Designated Router.
D. There is an incorrect DLCI assigned on a point-to-point sub-interface.
Answer: C

4. EIGRP applies the principle of Feasible Successor (FS) in resolving a new path to a lost route. What statement regarding the FS is correct?
A. Information is stored for the FS as part of the Link-State Routing updates forwarded for EIGRP.
B. EIGRP estimates the FS from each neighbor for each network after an exchange of database information during the normal update process. It uses this information for path selection when a route is lost.
C. When EIGRP is notified that a route is lost, it will always send requests to each neighbor for ways to reach the lost route. The neighbor that returns the best path will qualify as the FS.
D. EIGRP nominates a central router as the FS for all lost routes during configuration.
Answer: B

5. The Hold-Down Timer used in Distance Vector protocols:
A. Sets the time limit of how long a router may keep a packet in its buffer, if the routing protocol is in the process of converging
B. Determines the number of seconds a router will wait before sending another update to neighbor routers
C. Sets a specific period for routers to neither accept nor advertise a route from a destination where an original route was recently lost
D. Sets a duration where routes are not accepted from the neighbor router that caused a routing loop
Answer: C

6. Which commands are valid in ethernet or ethernet VLAN attachment circuits?
A. match cos
B. match ethernet cos
C. match source-mac
D. match vlan
E. match ethernet multicast
Answer: AD

7. What kind of packet is being decoded, using the captured debug mpls l2transport packet data command, below?
A. HDLC
B. PPP
C. Ethernet
D. RFC 2427/RFC1490
Answer: D

8. What Q.931 message cannot be received in response to sending a Q.931 SETUP message?
A. Alerting
B. Call Proceeding
C. Connect
D. USER Information
E. Progress
Answer: D


2.